In this video I show you step by step how to install the Blink video doorbell. I show the wired installation process. You need to download the Blink video doorbell app before you start the install process. It will walk you through the install process and let you know about important warnings and things you need to know during the install process. Make sure you are wearing the proper safety equipment and take all safety precautions while installing the Blink video doorbell. I will link a video at the end of this video showing you how to test a doorbell transformer and a playlist for my Fluke 117 if you want to learn about those please check them out. Thanks for watching! Please consider becoming a supporter if you enjoyed this video. Become A Supporter At 🤍🤍patreon.com/toddsgarage Intro/Outro Music: RKVC - Tropical Thunder Middle of video music: Patrick Patrickios - Good Times Disclaimer: Due to factors beyond the control of Todd's Garage, I cannot guarantee against improper use or unauthorized modifications of this information, or use of this information. Todd's Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Todd's Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Todd's Garage, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Todd's Garage.
Really need explanation of connecting to Blink app, also testing it.
The connection was different on mine. The wires go to the actual camera and not the mount.
Hi I installed the same way you did, but the chim inside the house doesn’t click with blink door bell? No sound comes from inside
The external power doesn't power the unit. It will only run on batteries.
Blink keeps going offline. It's frustrating because it says reset or reinstall.
I'm not doing that when it goes offline constantly.
So you needed to put the batteries in even though it was wired?
frsIf9ERjkM&t=6m28s 6:28 wires part
My old doorbell is so low
Is it secure? I see you just snapped it into place. Can someone just come and unsnap it to steal it?
Hi,
If you connect to wired, wire give Power supply? Battery charging?
you didn't test it.
I have different plate
I am switching to Blink from another video doorbell. It had a device that I had to wire into my existing doorbell. When I hooked it up without that, the bell buzzed constantly as the video doorbell actually completed the circuit somewhat. Will I have that problem with the Blink?